Showing posts with label wet leaves. Show all posts
Showing posts with label wet leaves. Show all posts

It looks like the leaf mulch is too thick on my lawn after shredding them under my trees. What am I doing wrong?

As the fallen leaves build up deep under large shade trees or if they are wet, a single pass of a mulching mower is often not sufficient to sufficiently shred them into small pieces. Sometimes several passes over the area will be required. (For best effect, mow "across the grain" on each pass.)

 For really deep pile of leaves, there are a couple of techniques to try: you can spread the leaves out (thin the layer) into other areas of the lawn before shredding. Alternately, a leaf blower can be used post-shred to help "even out" the mulch over-burden across the lawn and/or into landscape beds. 

A deep pile of leaves can be "attacked" by raising up the front of the mower and coming down on top of the pile, over and over, to pre-shred. Then perform a normal pass with the mower.

Other possible factors? The height of the mower deck (thus the blade height) might need to be adjusted lower to keep leaf shreds under the mower and in the blade path longer. Is the mulch gate (deck door) closed? Perhaps the blades have not been sharpened recently?

Are ticks an issue due to Mulching-In-Place?

LELE leaf mulching, when done with appropriate equipment and easy-to-learn techniques, results in very finely shredded leaf mulch. This is not what is termed in the scientific literature as “leaf litter.” Leaf litter consists of piles of whole leaves, typically found under trees and/or at yard margins such as along a fence, wall, or foundation. Leaf litter may be an attractive home to ticks.

While there are no specific studies yet published on the impact of LELE practices on tick populations in suburban lawn areas, the available research allows one to reasonably conclude that there should be no increase in tick populations due to the fine mulching/shredding of leaves. In fact, population reduction would be expected. One important factor leading to this conclusion is that shredded leaves differ significantly from whole leaves since they provide a micro-environment that is lower temperature and humidity, thus an environment less hospitable to ticks.

The recommended LELE practice of leaving leaves alone in wooded areas should not cause any increase in ticks: the net impact will not be significantly different from naturally occurring levels. Other environmental factors including rodent population levels and acorn crop density will have a more direct effect on increased tick populations. Because of this, composting mulched leaves and/or grass clippings along with food waste, if undertaken by the homeowner, should be carefully monitored for rodent attraction.

Note also that there has been reports of a greater density of ticks in leaf litter under Barberry shrubs.


Read more background - what we know about ticks - an interview with Dr. Rick Ostfeld of The Cary Institute.

Listen to a podcast from "A Way To Garden" concerning the latest on backyard tick research, with Dr. Neeta Connally.

Final thoughts from a sustainability perspective:

What LELE practices provide at their heart is the low-cost restoration of a natural waste management cycle back into the landscape, by allowing the nutrients locked up into leaves to be re-cycled into the soil (on lawns or in garden beds). By the simple technique of finely shredding such leaves, the breakdown and decomposition of said materials occurs at an accelerated rate. Soil quality, water retention, and plant health are all improved.

Complete removal of leaves from properties, suggested by some as a solution to ticks, actually robs both your soil and plants of much needed nutrients and micro-nutrients, and incurs associated costs in higher erosion, loss of biodiversity, damage to roots and re-generating seedlings, and disruption of natural aesthetics. 

Read a more detailed analysis surveying some available tick research in this context.


What are some LELE Tips for Landscapers?

Some simple tips for effective and efficient mulch mowing from landscapers experienced with LELE practices in the field:

  • SLOW DOWN! Mulch mowing is different than grass mowing. (Slower speed allows finer leaf chop.)
  • Install mulching blades (e.g.; “Gator" blades or mower brand-specific blades) on mowers.
  • Close the mulch plate on the mower deck.
  • Keep your mower blades well-sharpened.
  • Mow grass high through the fall so that leaf shreds can settle between grass blades.
  • Adjust the blade height to 2.5-4 inches high. (You'll need to experiment to determine optimum setting for your mower and site turf conditions to maximize leaf chop and minimize throw from under the deck.)
  • Mulch when leaves are dry or semi-damp, whenever possible.
  • Take on no more than 2/3 or 3/4 of a deck's width of material at a time. (With a full deck's width, you may be making the machine work too hard, often resulting in the “toss” of some un-chopped leaves right out the front and sides of the mower deck - it's simply a case of too many leaves at a time for the mower.)
  • Face mower discharge to the work-to-be-done side for easy re-grind when necessary.
  • If required, multi-pass to shred leaves completely (around 1" square is target size).
  • On subsequent passes, use a criss-cross pattern over the lawn to minimize rutting.
  • With deep leaf piles, raise the front of the mower to "attack" into the pile, then lower deck back down. Repeat this "raise & lower" chopping technique as required. (Hint: a counter weight on the rear of the deck helps reduce the effort to raise/tilt the chassis.)
  • Blow excess leaf shred on surface of turf across a wider lawn area to even out. Excess shred can also be blown into nearby landscape beds as a mulch.
  • Mulch mow collected leaves next to a target area where you desire to use the resulting mulch.
  • Learn the ROLLING CHOP technique to allow the mulcher man to work in concert with the man with the blower so that in a short time, everything is processed "in situ." (See details here.)